Cobra Colour Control 12 Manual de usuario descargar pdf (Pagina 12)

Notes:

This is the process of copying your entire show to another Colour Controller. This will not work with any other

device.

This process can take several minutes to complete.

The controller will automatically begin sending the FILE DUMP once the mode has been selected. Therefore

be sure that the other device has previously been set up to accept the transfer.

During FILE DUMP all other operations will cease to function.

If errors or power failure occurs, FILE DUMP will be interrupted and stop.

Maintenance:

The COBRA Colour Control 24 requires almost no maintenance. However you should keep the unit clean.

Disconnect the mains power supply and then wipe the cover with a dry cloth. Do not immerse in liquid. Do

not use alcohol or solvents.

Keep connections clean. Disconnect electric power and then wipe the DMX and audio connections with a

dry cloth.

Troubleshooting:

If fixture is not responding to DMX:

1. Check all connections are correct.

2. Check DMX addressing is correct.

3. Check blackout is turned off.

4. Check polarity switch at the back of the unit is in the correct position.

5. Check fade slider is up to the top.

6. Check Master A is at the top and B is to the bottom.

7. If all the above doesn’t work, unplug from the mains, wait 30 seconds then plug back in.

8. If it is still not working, contact your dealer.

1 2 ... 7 8 9 10 11 12

Sin comentarios

Cobra Colour Control 12 Manual de usuario Pagina 12