10
4. Whilst holding Record, press the flash button corresponding to the DMX output that you wish to assign
the fader to.
5. Repeat steps 2-3 as often as necessary.
6. Press and hold Rec and push Rec Exit.
EXAMPLE: You wish to assign fader #1 to output of DMX channel #5.
1. Hold the record button and press Flash button #6 three times.
2. Press Flash button #1.
3. While holding the Record button, press the Flash button #5.
Notes:
All physical faders can be reassigned to output on a different DMX channel. Faders are given a channel
number and are labled on the surface of the controller as such.
You can check to see what the assignment is by pressing the fader button of the corresponding channel while
in this mode.
There is no limit to the amount of channels that can be assigned to single fades. One can assign up to all 48
channels of DMX output to a single fader.
Auxiliary Controls:
This is the process of assigning the Auxiliary controls. These will act as shortcuts and are most commonly
used for DMX strobe lights or DMX fog machines. However they are not limited to these functions and can be
used for Pan/Tilt control. This is very useful for remote follow spot controls.
1. Press and hold Record and tap the Flash button #7 or #8 three times. This display should indicate
activation of the mode. (Flash button #7 is for AUX1 and Flash button #8 is for AUX2).
2. There are 3 functions:
FUNC 1 states that the auxiliary control is off.
FUNC 2 refers to the auxiliary controls. They work the same as the channel fader does with fader control
with knob and flash control with button.
FUNC 3 AUX is set to latch. The rotary knob controls the intensity and will only work when the flash
button is pressed.
3. Whilst holding down the Record button, select the function you wish for the auxiliary by pressing Flash
button #1, #2 or #3. Release the buttons.
4. To assign the auxiliary to a channel, press the Flash button for the channel you wish to assign the
auxiliary control to. This sets the channel assignment. The corresponding LED above the channel will
light, indicating that the channel has been assigned.
5. Press Record and tap Rec Exit buttons to exit this mode.
Notes:
You may refer to display for the functions being edited.
Press #7 three times for AUX1 patching and #8 three times for AUX2 patching.
While assigning an auxiliary to mode 2, the fader for that channel will not function. It will act as moving the
channel.
While assigning on auxiliary to mode 3, the channel fader and the auxiliary controls will both work for that
channel on an HTP (highest takes precedent) operating principle.
MIDI Operation:
The controller will only respond the MIDI commands on the MIDI channel that it is assigned to. All MIDI
control is performed using Note on commands. All other MIDI instructions are ignored. To stop a chase, send
the Blackout On note.
Setting MIDI IN:
1. Whilst holding down the Record button, simultaneously tap the Flash button #1 three times. The display
reads MIDI CHANNEL IN to indicate the channel setup is available.
2. Select the MIDI control channel (1-16) by tapping Flash buttons #1-16. The relevant channel LED light
(9 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales