Cobra Colour Control 12 Manual de usuario descargar pdf (Pagina 14)

Midi out mode

1.Press and hold the record button.

2.Press flash button 2, three times.

3.Release the record button.

4.The display shows CH-0 and the controller is in midi out mode.

5.Select the desired midi channel by pressing the respective flash button.

6.Hold down the record button and press record exit.

Midi run

1.If midi data is not received within 10 minutes, the channel and programme turned on by midi will

turn off.

2.When sending/receiving a file dump, the device ID is 55H.

3.The different functions of individual notes are as follows.

Receive a Sys-ex Dump

1.Press and hold the record button.

2.Press the flash button 3 in pre-set A, three times.

3.Release the record button.

4.When the display shows IN, the controller is ready for receiving the dump.

When receiving the dump, all other functions are switched off. As soon as the transmission is

complete or cancelled due to errors, the controller returns to normal operation mode.

Send a Sys-Ex dump

1.Press and hold the record button.

2.Press the flash-button 4 in Pre-set A, three times.

3.Release the Record-button.

4.When the display shows OUT, the controller is ready for sending the dump.

When sending the dump, all other functions are switched off. As soon as the transmission is

complete or cancelled due to errors, the controller returns to normal operation mode.

Notes:

This is the process of copying your entire show to another colour controller. This will not work with

any other makes of device.

This process can take several minutes to complete.

The controller will automatically begin sending the file dump once the mode has been selected.

Therefore ensure that the other device has been set up to accept the transfer.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Sin comentarios

Cobra Colour Control 12 Manual de usuario Pagina 14