Cobra Colour Control 12 Manual de usuario descargar pdf (Pagina 10)

Entering Program Mode (|Record Enable)

1.Whilst holding down the record button, press flash button #1-6-6-8 in sequence.

2.Release the record button. The record LED lights up.

Exiting Program Mode

1.Hold record/shift button then tap rec exit button.

Create a Scene/Chase

1.Record enable.

2.Select the 1-48 single mode by tapping the mode select button. This will give you control of all 48

channels.

3.Create desired output by adjusting the faders (changes in fixture attributes such as colours &

gobos, or simply dimmer values).

4.Press record to save the look into the temporary memory.

5.Repeat steps 2-4 until you have your desired chase.

6.Do not repeat steps 2-4 if you are only saving scene.

7.Select a scene master to store your scene. Tap the page button to select a page (1-4)

8.Press and hold the record button and tap the flash button for the scene that you wish to store to.

All LED’s will flash indicating the scene has been programmed in to memory.

9.You can continue programming in this way or exit. To exit program mode, press and hold the

record button and tap the rec exit button, the record LED will dim out.

Notes:

Deselect Blackout if LED is lit.

If you wish to create a static look, then you must create a scene composed by only one step. There

are 999 steps in total you can use.

Edit Enable

1.Record enable.

2.Use the page button to select the page that the program you wish to edit is on.

3.Tap the mode select buttons, to select chase/scenes.

4.Press and hold the edit button and tap the flash button (25-48) of the scene/chase you wish to

edit.

5.Release the edit button. The relevant scene LED should illuminate, indicating you are in edit

mode.

Notes:

This mode is displayed here only for the initiation of edit mode. Please see the following sections for

uses of this mode in more detail.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Sin comentarios

Cobra Colour Control 12 Manual de usuario Pagina 10