Cobra CPI2550 Instrucciones de operaciones descargar pdf (Pagina 10)

Nothing Comes Close to a Cobra

English

Turning Your Inverter On or Off

•

Be sure to have your power inverter properly installed before

attempting to turn the unit on (see installation page 6).

To turn the power inverter on:

1. If a DC power supply is being used as the power source,

switch it on.

2. On the left side panel, switch the On/Off Switch to on.

The inverter is now ready to deliver AC power to your loads. If

several loads are to be operated by the inverter, turn them on

separately, after the inverter has been turned on. This will

ensure that the inverter does not have to deliver the starting

currents required for all the loads at once.

To turn the power inverter off:

1. On the left side panel, switch the On/Off Switch to off.

NOTE The On/Off Switch turns the control circuit

in the inverter on and off. It does not disconnect

power from the inverter.

When the switch is in the off position, the inverter

draws no current from the battery. When it’s in the

on position, but no power is being supplied to the load,

the inverter draws less than 500 milliamperes from the

battery. This is low current draw. It would take more

than a week to discharge a 100 ampere-hour battery at

this rate depending on the age of the battery.

Remote On /Off Switch (not included)

•

An optional Remote On/Off Switch (not included) can be

connected to the Remote Jack allowing you to turn the

Cobra power inverter on or off from a convenient location when

the inverter is installed in an out of reach location.

Power On and Off

Operation

Remote On/Off Switch

Operation

On/Off Switch to On

Remote Switch

Remote Jack

On/Off Switch to Off

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Sin comentarios

Cobra CPI2550 Instrucciones de operaciones Pagina 10